FREE TOOL

BLE advertising calculator

How often should your device advertise? Move the slider and watch the battery answer.

Advertising
ms
Shorter is found faster. Longer lasts longer.
Power
Advanced assumptions
Estimated battery life

21 months

Average current 12 µA: 10 µA advertising plus 2 µA asleep.

Average gap between events
1,005 ms
On-air time per packet
376 µs
Radio busy per event
1,578 µs
Charge per event
10.07 µC
Events per day
85,970
Awake
0.187 % of the time

Same device, other intervals

Everything else stays as you set it. Your current choice is highlighted. * Past ten years, self-discharge decides.

IntervalAverage currentBattery life
404.7 µA19 days
97.9 µA3 months
65.9 µA4 months
48.6 µA5 months
25.8 µA10 months
11.8 µA21 months
7 µA2.9 years
4 µA5.1 years
3 µA6.9 years

How it’s calculated

Every advertising event sends the same packet on each advertising channel (37, 38 and 39), then the radio sleeps until the next event.

  • On-air time per packet = (1 preamble + 4 access address + 2 header + 6 device address + your data + 3 CRC) bytes × 8 µs. A full 31-byte payload takes 376 µs on the 1M PHY.
  • Gap between events = your interval + a random delay of 0 to 10 ms that the specification adds to avoid collisions. The calculator uses the 5 ms average.
  • Charge per event = channels × (on-air time + radio overhead) × transmit current + wake-up time × wake-up current.
  • Average current = charge per event × events per second + sleep current.
  • Battery life = capacity × usable share ÷ average current.

What it leaves out

  • Scan requests and connection requests. A connectable or scannable device also listens briefly after each packet, which costs a little more.
  • Extended advertising, the 2M and Coded PHYs, and periodic advertising.
  • Sensors, LEDs and anything else your firmware wakes up for.

Treat the number as a planning estimate. The real answer comes from measuring your board with a power profiler, over a full advertising cycle.

Choosing an interval

Short intervals make a device quick to find and expensive to run. Long intervals do the opposite. A common pattern is to advertise fast for a short while after power-up or a button press, then slow down.

For iPhone discovery, Apple’s Accessory Design Guidelines recommend advertising at 20 ms for at least the first 30 seconds, then switching to one of a set of longer values: 152.5, 211.25, 318.75, 417.5, 546.25, 760, 852.5, 1022.5 or 1285 ms. The list has changed between guideline versions, so check the current edition before you ship.

A worked example

A sensor tag on a CR2032 sends 31 bytes on all three channels every second, with 6 mA transmit current and 2 µA sleep current. Each event keeps the radio busy for about 1.6 ms and costs about 10 µC, so the device averages about 12 µA. At 80% of 225 mAh, that is about 21 months. Slow it to every 2 seconds and the average drops to about 7 µA, which stretches it to almost three years.